EPA announces study plan for hydraulic fracturing

Nov. 4, 2011
The U.S. Environmental Protection Agency has announced its final research plan on hydraulic fracturing. At the request of Congress, EPA is working to better understand potential impacts of hydraulic fracturing on drinking water resources.

WASHINGTON, Nov. 4, 2011 - The U.S. Environmental Protection Agency has announced its final research plan on hydraulic fracturing. At the request of Congress, EPA is working to better understand potential impacts of hydraulic fracturing on drinking water resources.

In March 2010, EPA announced its intention to conduct the study in response to a request from Congress. Since then, the agency has held a series of public meetings across the nation to receive input from states, industry, environmental and public health groups, and individual citizens. In addition, the study was reviewed by the Science Advisory Board (SAB), an independent panel of scientists, to ensure the agency conducted the research using a scientifically sound approach.

The initial research results and study findings will be released to the public in 2012. The final report will be delivered in 2014. To ensure that the study is complete and results are available to the public in a timely manner, EPA initiated some activities this summer that were supported by the SAB and provide a foundation for the full study.

The final study plan looks at the full cycle of water in hydraulic fracturing, from the acquisition of the water, through the mixing of chemicals and actual fracturing, to the post-fracturing stage, including the management of flowback and produced or used water as well as its ultimate treatment and disposal. Earlier this year, EPA announced its selection of locations for five retrospective and two prospective case studies.

More information: www.epa.gov/hydraulicfracturing

Sponsored Recommendations

NFPA 70B a Step-by-Step Guide to Compliance

NFPA 70B: A Step-by-Step Guide to Compliance

How digital twins drive more environmentally conscious medium- and low-voltage equipment design

Medium- and low voltage equipment specifiers can adopt digital twin technology to adopt a circular economy approach for sustainable, low-carbon equipment design.

MV equipment sustainability depends on environmentally conscious design values

Medium- and low voltage equipment manufacturers can prepare for environmental regulations now by using innovative MV switchgear design that eliminates SF6 use.

Social Distancing from your electrical equipment?

Using digital tools and apps for nearby monitoring and control increases safety and reduces arc flash hazards since electrical equipment can be operated from a safer distance....