Renewable energy drive could intensify water scarcity, says new report

March 20, 2014
Increases in global energy requirements could lead to a rise in the energy sector’s water footprint of up to 66% in the next 20 years, new research suggests...

Increases in global energy requirementscould lead to a rise in the energy sector’s water footprint of up to 66% in the next 20 years, new research suggests.

The report, entitled The Water Demand of Energy: Implications for Sustainable Energy Policy Development, said that renewable sources, such as biofuels and large-scale hydropower have large water footprints which must be considered in energy policies.

Globally, average energy demandis expected to rise from 81.2 gigajoules (GJ) per person in 2012, to 96 GJ in 2035, which, incorporating population growth, will increase energy demand by 40% over the next 20 years, according to the report.

While all forms of energy generation require water, total demand varies significantly between energy sources. As the energy sector expands, this water demand must be taken into account to ensure best use of limited resources, the findings said.

In January the World Bank launched an initiative called Thirsty Energy which set out to help governments coordinate decision making when it comes to water and power projects (see WWi article).

In the US it has been estimated that the energy sector is likely to account for 85% of the projected increase in domestic water consumption between 2005 and 2030, but this will depend on the energy mix used.

For example, biofuels require 37-42 m3 of water to produce one gigajoule of energy, and large hydropower systems need 22 m3/GJ, (mainly as a result of water loss due to evaporation from reservoirs). However, the water footprint of coal-powered energy generation is between 0.15–0.58 m3/GJ and wind power is as low as 0.0001 m3/GJ.

The study estimated the amount of freshwater needed to produce energy on a global scale for the period 2012-2035, based on five energy mix scenarios presented in the US Energy Information Administration’s (EIA) International Energy Outlook1.

The researchers used life cycle analysis and established water footprints to measure the volume of water consumed in energy production for each scenario. They included 10 different energy technologies, including fossil fuels and a range of renewables, such as biofuels, hydroelectric, solar and wind sources.

The results revealed that, over the next 20 years, the water footprint of the global energy sector could increase by a minimum of 37% and by a maximum of 66%. The minimum estimate was based on the EIA’s ‘LOP scenario’, which assumes lower oil prices and, consequently, a lower share of water-intensive renewable sources in the energy mix relative to the ‘HOP scenario’. The HOP scenario, on which the maximum estimate was based, assumes higher oil prices.

The large water footprint (between 55%-66% higher than the 2012 water footprint) under the HOP scenario is expected as a result of an increase in the use of renewable energy sources, such as biofuels and large-scale hydropower, in response to high oil prices.

These results suggest that increasing the share of such water-intensive renewables could exacerbate water shortages, the researchers said.

###

Read more

Water scarcity now linked to slowing energy production A new initiative has been launched by the World Bank that aims to link the water and power industries better globally. Called Thirsty Energy, the initiative will help design “assessment tools and management frameworks” to help governments “coordinate decision-making” when it comes to scaling up water and power projects…

Sponsored Recommendations

NFPA 70B a Step-by-Step Guide to Compliance

NFPA 70B: A Step-by-Step Guide to Compliance

How digital twins drive more environmentally conscious medium- and low-voltage equipment design

Medium- and low voltage equipment specifiers can adopt digital twin technology to adopt a circular economy approach for sustainable, low-carbon equipment design.

MV equipment sustainability depends on environmentally conscious design values

Medium- and low voltage equipment manufacturers can prepare for environmental regulations now by using innovative MV switchgear design that eliminates SF6 use.

Social Distancing from your electrical equipment?

Using digital tools and apps for nearby monitoring and control increases safety and reduces arc flash hazards since electrical equipment can be operated from a safer distance....