Odor monitoring

April 1, 2013
ATI's designated model Q45S is an odor monitoring system that uses the company's standard Q45 electronics package in conjunction with a special "Wet H2S" sensor.

ATI's designated model Q45S is an odor monitoring system that uses the company's standard Q45 electronics package in conjunction with a special "Wet H2S" sensor. Measurements may be made either at the inlet to scrubber systems where concentrations can run as high as 200 PPM, or at the outlet where concentrations are ideally down below 0.5 PPM. Special sensor configurations are available for either duct insertion or flowcell use. An optional air-purge system controlled by the transmitter will periodically deliver a blast of air across the critical sensor surfaces to remove water droplets. This system insures a clear gas diffusion path to the sensor and reliable measurements on a continuous basis.

Analytical Technology Inc.
www.analyticaltechnology.com

More WaterWorld Issue Articles
WaterWorld Articles Archives

Sponsored Recommendations

NFPA 70B a Step-by-Step Guide to Compliance

NFPA 70B: A Step-by-Step Guide to Compliance

MV equipment sustainability depends on environmentally conscious design values

Medium- and low voltage equipment manufacturers can prepare for environmental regulations now by using innovative MV switchgear design that eliminates SF6 use.

Social Distancing from your electrical equipment?

Using digital tools and apps for nearby monitoring and control increases safety and reduces arc flash hazards since electrical equipment can be operated from a safer distance....

Meet the future of MV switchgear

SureSeT new-generation metal-clad. Smarter. Smaller. Stronger.