Draft Hydraulic Fracturing Study Plan

Feb. 1, 2011
WASHINGTON, DC, Feb. 8, 2011 -- The U.S. EPA has submitted its draft study plan on hydraulic fracturing for review to the agency's Science Advisory Board...

WASHINGTON, DC, Feb. 8, 2011 -- The U.S. Environmental Protection Agency (EPA) today submitted its draft study plan on hydraulic fracturing for review to the agency's Science Advisory Board (SAB), a group of independent scientists. Natural gas plays a key role in our nation's clean energy future and the process known as hydraulic fracturing is one way of accessing that vital resource. EPA scientists, under this administration and at the direction of Congress, are undertaking a study of this practice to better understand any potential impacts it may have, including on groundwater. EPA announced its intention to conduct the study in March 2010 and use the best available science, independent sources of information, a transparent, peer-reviewed process and with consultation from others. Since then, EPA has held a series of public meetings across the country with thousands attending and the agency has developed a sound draft plan for moving forward with the study.

The scope of the proposed research includes the full lifespan of water in hydraulic fracturing, from acquisition of the water, through the mixing of chemicals and actual fracturing, to the post-fracturing stage, including the management of flowback and produced or used water and its ultimate treatment and disposal.

The SAB plans to review the draft plan March 7-8, 2011. Consistent with the operating procedures of the SAB, stakeholders and the public will have an opportunity to provide comments to the SAB during their review. The agency will revise the study plan in response to the SAB's comments and promptly begin the study. Initial research results and study findings are expected to be made public by the end of 2012, with the goal of an additional report following further research in 2014.

Hydraulic fracturing is a process in which large volumes of water, sand and chemicals are injected at high pressures to extract oil and natural gas from underground rock formations. The process creates fractures in formations such as shale rock, allowing natural gas or oil to escape into the well and be recovered. Over the past few years, the use of hydraulic fracturing for gas extraction has increased and has expanded over a wider diversity of geographic regions and geologic formations.

For a copy of the draft study plan and additional information: http://yosemite.epa.gov/sab/sabproduct.nsf/02ad90b136fc21ef85256eba00436459/d3483ab445ae61418525775900603e79!OpenDocument&TableRow=2.1#2

More information on hydraulic fracturing:
www.epa.gov/hydraulicfracturing

###

Sponsored Recommendations

NFPA 70B a Step-by-Step Guide to Compliance

NFPA 70B: A Step-by-Step Guide to Compliance

How digital twins drive more environmentally conscious medium- and low-voltage equipment design

Medium- and low voltage equipment specifiers can adopt digital twin technology to adopt a circular economy approach for sustainable, low-carbon equipment design.

MV equipment sustainability depends on environmentally conscious design values

Medium- and low voltage equipment manufacturers can prepare for environmental regulations now by using innovative MV switchgear design that eliminates SF6 use.

Social Distancing from your electrical equipment?

Using digital tools and apps for nearby monitoring and control increases safety and reduces arc flash hazards since electrical equipment can be operated from a safer distance....